Shop Photos and Facility
Short answer. Nine views of the parts of the shop that decide whether a job can be done correctly: bay depth, booth length, the laminate station, the slide bench, the frame jig and the fleet staging yard. Come walk it in person if you would rather.
The main body bay
The bay depth is what lets a forty foot coach come all the way inside instead of getting worked on in a yard.
Paint booth, coach length
A full length booth is the difference between a controlled refinish and a job shot outdoors with dust in the clear.
Fiberglass and laminate repair station
Delamination work needs vacuum, heat and time. This is where a sidewall gets pulled back to sound laminate.
Slide room on the bench
Pulling the room is the only honest way to inspect the floor, the rails and the seal channel at once.
Frame and structural jig
Measurement first. Nothing gets pulled until the reference points are recorded.
Roof work platform
Working a roof from a proper platform means the crew can see every seam instead of reaching from a ladder.
Fleet staging area
Staging lets a fleet keep running. We sequence units so only one is down at a time.
Color match and mixing room
Sun faded gelcoat never matches the factory code. The spray out card decides the formula, not the paperwork.
Parts and staging shelves
Every job gets its own staging space so a special order cap or door is not lost between phases.
What you are actually looking for in a shop photo
Most shop galleries show a shiny finished vehicle parked outside in good light. That tells you almost nothing. The finished photo is the easy part of any job, and it is the part a mediocre repair and a correct repair look most alike.
What matters is the middle. Is there a bay deep enough to take a forty foot coach fully inside. Is there a booth long enough to shoot a full side in one pass instead of chasing a blend joint down the panel. Is there a bench big enough to set a slide room down on and inspect all four sides. Is there measuring equipment near the frame work rather than a chain and a hope.
That is what the photo slots on this page are organized around. Each one is a capability, not a beauty shot.
Why before and after pairs get shot from the same position
A before and after pair is only honest if the camera did not move. Change the angle, the distance or the light between the two frames and you can make almost any repair look better than it is.
Our pairs are shot from a marked position at intake and again at delivery. Same lens, same distance, same side of the vehicle. If a repair does not hold up under that, it is not finished.
The same discipline is what makes documentation useful on a claim. An adjuster reviewing a supplement is comparing frames. Consistency is the whole point.
How this documentation supports your claim
Every vehicle that comes in gets photographed at intake before anything is touched. When a panel comes off and reveals damage the first estimate never saw, that gets photographed too, in place, before removal.
That sequence is what a supplement rests on. Without it the conversation with a carrier is one person's word about what was behind a cap. With it, the file shows the condition, the discovery and the work in order.
Owners who bring their own scene photos from the day of the incident give us a stronger starting point. Wide shots that show the whole vehicle and its surroundings are more useful than close ups of a single crack.
Questions about the gallery
Why are there no stock photos on this page
Because stock photos of somebody else's shop are misleading. We would rather describe exactly what belongs in each slot and fill it with our own work than show a stranger's bay and imply it is ours. If you want to see the facility before committing a vehicle, call and come walk it.
Can I see work on my specific vehicle type
Call and ask. We keep job documentation on file and can usually pull comparable work on the same class of vehicle. For fleet accounts we can show livery matching and multi unit staging on units similar to yours.
Do you document my repair as it goes
Yes. Photo documentation at intake, at teardown and at each phase is part of how a supplement gets justified to a carrier. That documentation belongs to your file and you can request it.
Can I tour the facility
Yes, during business hours. Call ahead so someone is free to walk you through instead of catching us mid job. Owners considering a large interior or paint project usually find the walkthrough worth the drive.
Ready to get a written estimate
We write estimates at the shop and bill your carrier direct. 30 to 45 minutes from West Covina on the 57 and the 91.